|
Mud Pump
 The P-750/G2 by American Augers is a stand alone-self powered mud pump that is the perfect accessory for use with mud motors, large reamers, or whenever more mud volume is needed down hole. The P-750/G2 should be considered when working in rock formations where the operating drills on-board mud pump has fluid-limited capacities, and can't simply produce enough pressure to drive the mud motor. Additionally the P-750/G2 allows the operator to get enough flow to keep the bore flushed clean of cuttings. The P-750/G2 is designed with a compact skid mounting, and provides a small footprint that is ideal for most drilling environments. Compatible with any drilling brand, the P-750/G2 should be the mud pump of choice for all drillers who operate a variety of sizes, makes, and models of drilling equipment.
Performance Specifications
|
Power Train
Engine: Caterpillar© C-18 Tier III, Diesel
Rating: 600 HP (447 kW)
Fuel Capacity: 300 Gallon (1,146 L)
Transmission: Eaton-RTLO-22918B, 10 Speed
Clutch: 15 1/2" (394 mm), Twin Disk
Battery: Two, Deka 908DMF,12V,1450 CCA |
Pump
Pump Design: Quintiplex, piston and liner
Rated Capacity: *750 U.S.Gallons (2,839 L)/min
Bore x Stroke: 5.5 x 7.87 in (139.7 x 200 mm)
Max. Pressure: 1500 psi (103 bar)
(*Note: Pump Capacity will Vary Depending on the Overall Mud Weight, Drilling Fluid Mixture/Content, and the Working Elevation |
|
Controls
Remote Controls: Mud Pump Throttle, Mud Pump Start/Stop, Clutch Actuator, Horn
Remote Instruments: Digital Mud Flow Meter (gallons per minute/liters per minute)
Dimensions/Weight
- Length: 25 ft 6 in. (7.8 m)
- Width: 8 ft (2.49 m)
- Height: 10 ft (3.12 m)
Estimated Weight:39,000 lbs (17,690 kg) |
Accessories
- Pulsation Dampener on inlet and discharge
- Two, 25 ft (7.6 m) suction hoses with 6“ (152 mm) Kamlok fittings
- 4" (101.6 mm) NPT Hammer Union Discharge Connection
- 33
U.S.
Gallons (125 L)/per minute Liner Wash System w/supply tank
- 24 V, Dual Work Lights
|
Mud motors offer the proven way to get acceptable penetration rates when drilling in hard formations and rock. The mud pump has to supply the mud motor, but also has to flush the cuttings to the surface for disposal. The table below shows typical flow rates for popular size mud motors. Be sure to allow enough extra mud flow to flood the bore. American Augers mud pumps can be used with any brand or size of directional drill
|
Mud Motor Size (Inch) |
3-3/8 |
3-1/2 |
4-3/4 |
6-3/4 |
8 |
|
Flow Rate (GPM) |
30-120 |
75-160 |
100-250 |
300-600 |
400 - 900 |
For Additional Mud Pump and Cleaning System equipment, please view the following options
MPR-6000 MCR-10000 MCM-4000 P-500/G2
|
